FluoroPel 500 is a fluoroacrylic copolymer solution for coating membranes, PCBs, glass, plastic and metal surfaces. Thin films dry in a few minutes at room temperature and provide a surface with a contact angle to water of approximately 110°. On membranes, mesh and filters, FluoroPel does not occlude pores and helps achieve oleophobicity grades up to 8. Formulations with fluorescent tracers are also available. Please contact Cytonix for custom formulations with different solvents such as mineral spirits, butyl acetate, MEK, acetone or help with product selection.
Size: 150 grams (~125 ml) Shelf life: Two years (in sealed unopened container) Application methods: Immersion, dipping, brushing, etc. Curing: Air dry at room temperature in 5 minutes (and bake 50°C for 10 minutes if possible) Appearance: Clear, odorless and colorless film Contact angle to water: >110° Contact angle to mineral oil: >65° Oleophobicity grade: >4 Hardness: >2B pencil Flammability: Non-burning Heat stability continuous:150°C Max heat stability one hour: 250°C Toxicity of films: HMIS Rating Health = 1 Ease of application: Excellent Solvent/chemical resistance: Excellent after curing Transparent: Yes Gas permeable: Yes (at 0.2% concentration) Electric conductivity: Yes (at <0.5 µm film thickness) Ease of drying: Dries at room temperature in <5 minutes
Application notes: Please make sure the substrate is free of dust and any other loose material. Dip the part in FluoroPel and allow to soak for about 30 seconds. Remove the part from the FluoroPel solution slowly (1 cm/second). The part will be dry in 60 seconds. If possible, bake at 60-100°C for 10 minutes to improve adhesion. FluoroPel can also be applied by spraying, damming, syringe-dispensing, etc.